The Dec Axis has a fair bit of Versa Plate movement when I move it back and forth by hand (as opposed to the RA axis which is tight). I have adjusted the Dec Spring Plunger and Cam stop according to instructions. When I make it too tight there is still there is a little less movement but the Dec axis will not drive. I taped a piece of paper (with a pencil mark) to the mount to show the movement. See attached files.
I am only a beginner with this well engineered mount. Obviously I think that the DEC axis should not have that much play. Please give me some suggestions or test that I could run.
Thank you,
Peter Von Stein